SIP Trunk Configuration Instruction with VitalPBX

Introduction

SIP Trunk Configuration Instruction with VitalPBX Example Configuration provides you with a step-by-step SIP Trunk Configuration of ProSBC with VitalPBX systems, using the Web Portal configuration tool. Complete general installation configuration steps, before you begin configuring your specific scenario. In this guide FQDN (vitalpbx.telcobridges.com) configured in the VitalPBX server. If you don't use FQDN, you can use the VitalPBX IP address too. Please check how to configure the SIP Trunk in VitalPBX for ProSBC from VitalPBX Trunk Creation

VitalPBX SIP Trunk Example

Configuration Steps

(Step 1) Create IP Network	(Step 2) Create Protocol Stack	(Step 3) Create Call Route
Configuring an IP Virtual Port Configuring a VLAN Configuring IP Interfaces Create an IP port range	Create an IP port range Create a SIP stack Create a SIP transport server Modify profile Allocate a SIP NAP	Create a first call route

NAP Configuration

• See Create SIP NAP

  • Here, You must create two NAPs, one SIP NAP will be VitalPBX NAP and the other NAP will be for the SIP trunk provided by ITSP